About this 3D model

Guides for the Neptune 3 and Neptune 3 Pro magnetic print beds. Used to make it easier to attach the printbed after it has been removed. Include a modified left guide in case you're using the attached Bobbylebob's scrap bin . This is a remix of another printed guide, but with changed dimensions to accommodate the Pro model's automatic bed levelling notch. The original model had a problem in which this notch collided with the left guide. These guides can also be used for the non-Pro model of Neptune 3, as guides are just smaller and require less material. In my case, they were printed with regular PLA, but temperature-resistant PLA may be preferable in the long run as the guides contact the magnetic printbed. Double-sided tape is used to attach the guides under the bed. The first photo shows where the guides are attached in case you're using the scrap bin. “ Printbed Guide (Right) ” should be attached to the right corner; “ Printbed Guide (Left) ” should be attached to the left corner (in case no scrap bin is used); “ Printbed Guide (Left, Bin) ” should be attached to somewhere between the cable and right corner (in case scrap bin is used).