About this 3D model

UPDATE -4/23/2013, Added a case with no buttons. - 2/19/2014, Night: Updated case on thin section between the hole and the buzzer port, and removed two holes near them. Improved alignment of buzzer port and voltage port. - 2/19/2014, Morning: Screw holes on the old base did not go all the way through, I used a drill to drill them out. I updated the design to have proper holes. Changes from 3dxl KK2.0 case design: 1) Flipped the case upside down because I did not want to print supports. Unfortunately you loose the little notches on the buttons, but I found I could still press them easily. 2) Changed the clipping and swivel of the case on the base to a screw fit. I used #6 bolts from Home Depot. 3) Changed the screw layout on the base to fit this design: http://www.thingiverse.com/thing:32281 4) Added holes for the KK2.1 board buzzer and battery power port on the case. I did not change the lid at all, but I left a screw hole in the middle of the base so that this could easily be changed. I do not use a lid on my quadcopter. Enjoy!