About this 3D model

Simple scale to report weight of filament spool. Link to code: https://create.arduino.cc/editor/alieneila/3f787723-b75e-495c-aea3-6f5319555509/preview Items used: 5kg Load Cell HX711 Amplifier Module 128 x 32 OLED Display 2 x 6700ZZ Bearings (10mm ID, 15mm OD, 4mm W) 5 x M3 2 x M5 2 x M4 10 x Female to Female Jumper wires ESP32-WROOM Dev Board There are 4 wires for the HX711 to Control Board, 4 wires for the OLED to Control Board, and 2 wires to cut the female ends off (leave about 2 inches of wire on each) to use to add connectors to the 4 Load Cell Wires. You can also shorted the load cell wires as you see fit. Additionally, the pins for the OLED can be bent about 45 degrees if you find that they're in the way from the HX711 clamp. Load Cell to HX711 Wiring: Red to E+ Black to E- White to A- Green to A+ HX711 to ESP32 Dev Board wiring: VCC to VIN GND to GND SCK to 18 D to 19 OLED to ESP32 Dev Board Wiring: VCC to 3.3v GND to GND SCL to 22 SDA to 21