About this 3D model

I like to fix things. So I fixed this: 1. reoriented for better print. 2. fixed inside of roof to be an inverted pyramid so you do not get a mess when printing the overhang (as much) 3. sculpted it a bit to save plastic and add a little more artistry. Enjoy. Rev 2 - A little stronger arms (rev 1 worked but is fragile - higher res sphere (the original one was way too blocky) - New sphere shaped indents in top and bottom to preven ball from sticking. Rev 3 - After a tip cleaning, I found that the ball sticks too well to the base when printing so added a little bump to move it up slightly. Recommend scaling by 1.25 (125%) for a good strong print. Enjoy again!!