About this 3D model

Spiderman SPIDER INSPIRED Web String Art. *please read instructions carefully* Walls MUST be set to archane. 0.2 layer height. 0.4 nozzle. do not change these as the string will not print correctly if at all. At least 15% infill so the strings have something to latch on to. any less again you increase the likleyhood of failed strings. Ignore the “floating regions” warning" I would recommend printing the strings a different colour, ive found that if strings are the same colour it prints differently and may fail. Each string from the frame to the center will print twice, so 2 layers. this is on purpose to ensure that if one string fails then another is printed. if both succeed then they adhere to each other. either way you end up with one good string. the web string prints once. This print had no failed strings. As with any string art there is potential for a failed string, do not worry. if you see a failed string pause the print and snip it off or wait until its finished although can be a little harder at this point. I have printed on the A1 and confirm the successful print on this printer. so if printing on another printer you may not get the same results. I also have a couple of other Spiderman inspired sting art designs so if your intersted please check out my profile, * So for those that sell. I am placing the legalities of selling this model in your hands, i take no responsibility if you choose to sell this item.