About this 3D model

~~This is the Commercial Use Bonus File for Dec 2024~~ Celebration Turtle is here to have a great time! With fireworks, party hats, and confetti! Just change the color scheme to match the celebration theme. The Celebration Turtle will be the final file of this month. Along with the typical 6mm eye socket version, the Celebration Turtle has another variation - an addition of a party favor. The party favor prints separately, to keep him no supports. If you want it in the Celebration turtle's mouth permanently, just add a small touch of glue. If you weren't part of this Patreon in previous months, here is the deal with this file: A Commercial Use file Bonus Turtle for all tiers for its specified month. This turtle will not go into the Welcome folder, and will only be sold on Cults and MMF as a Commercial Use file when its month is over. The only way to get these files will be from being a Patreon or MMF Tribes subscriber for the month it is released in, or buying it off of cults/MMF store at a later date. Once you receive it/buy it you can sell physical copies (only) for life. I'm hoping this will help slowly building up a person's collection of CU files, while also adding more value to subscribing. Print Settings: Print in Place No Supports needed 2-3 walls 5-10% infill If you have adhesion issues, try a brim, glue stick or Aquanet hairspray Do to the nature of this file being CU, I've included the Big round pupil eyes file that fit in this model below. Layer Printable eyes: Big Round Pupil Eyes They aren't as cool looking as glass eyes, but in a pinch, or needing a bulk amount these eyes will be available and quick to print! Because these are 6mm in size, they should fit on any model that has eye sockets. This means that you can also scale both the model and the eyes to different sizes. I have had success at 80% eyes (a little tight but they work!) and 220% size. The only thing to keep in mind is that if you scale massively higher the eye slot in the model might be more visible ( you will need to scale the eye larger for it to fit better). Scaling the eyes too small may cause the areas to layer change to merge. Print Settings: Print in Place No Supports needed 2-3 walls 5-10% infill If you have adhesion issues, try a brim, glue stick or Aquanet hairspray For 6mm eye (100% size) printing - layer change/ pause at: 0-1mm black 1-1.4mm Iris color 1.4mm - finish white Smaller layer heights may give better details, likely even a smaller nozzle, which I do not have one of to test. Filaments Used: Esun black, Eryone rainbow matte, OVV3D silk gold, Bambu white