About this 3D model

Most resin printers have a "cleaning" mode which cures a layer of resin on the bottom of the printer to let you clear out failed prints without draining the vat. However, it can be a real pain to get the cured resin off the bottom of the vat. This is a disposable puller which can be printed on an FDM printer, and placed in a corner of the vat when running a clean. The resin cures around the puller, allowing you to lift it out of the vat without digging around in the resin. You may need to hold it down with a finger while the process runs as it may float in the resin depending on the resin you use and how full the fat is. The puller has hooks to let you hang the cured layer to drain and then cure. There are other designs like this, but this one: - Has round plugs which makes it less likely to tear the cured layer when pulling it out - Has a hook to hang it up - Is designed for fast batch printing I've included a hanger for the Saturn 2 which fits over the build plate arm for draining but you're on your own for other printers.