About this 3D model

This is a plastic enclosure for [RETRO Innovation's uIEC CBM floppy disk drive emulator card](http://store.go4retro.com/products/uIEC_SD.html) for the Commodore 64. It has been designed to enclose the uIEC and its deluxe daughtercard in their L-shaped configuration. It is a pretty narrow fit, with supports to prevent the electronics inside from moving around too much when it is being plugged into the cassette port of the C64. It has 4 holes, one for the dataset connector, another one for the IEC cables, one for the SD card and one above the four control buttons on the uIEC card. It also has a little support (the tail of the bunny) which slides below the C64 to prevent the mechanical force which would be forcing the whole dataset connector upwards because of the layout of the uIEC card itself. It has been designed for the C64-i (the classic model), I don't know if it is needed and if works with the C64-ii at all. UPDATE: Added the model files for the buttons and their little box which can be used to access the 4 buttons (fwd, back, swap, reset) on the circuit. UPDATE: Updated the files so that the SVG files are easier to edit.