About this 3D model

This adjuster is designed to go with the stock MakerGear Prusa Z endstop. This one-piece design is very simple and yet functional. I decided to place the adjustment screw at a thick part of the block so that's why it is asymmetrical. This slides onto the ends of the smooth bars and is secured by 2- M3 screws from the bottom. The adjustment screw goes through the M3 nut in the nut trap. Once installed, you just need to lower the Z endstop by about 5 millimeters and swing it out to align the lever with the adjustment screw. Fine adjustments are made by turning the adjustment screw. This eliminates the need to tweak the Z offset in your slicer software.