About this 3D model

E3D-V6 mount for the Ultimaker 1 -- is remixed from Musti's E3D mount.(http://www.thingiverse.com/thing:145988) The interior, which holds the E3D (E3D-v6) all metal heatsink bowden edition, is redesigned for the v6 version. Just order from E3D online: - v6 Heatsink 3mm bowden - v6 heat sink break 3mm - 30x30x10mm DC fan Then print the parts and you are good to go. I used the original UM1 heater block, extruder nozzle and thermocouple and printed these parts in ABS. Also printed the fan-duct from Musti, which I had to remix slightly post print using a set of pliers to cut away some plastic so the original UM1 heater block does't touch the fan duct. (Too impatient to redesign the fan-duct for this setup :-)) If you need it and are not in the position to print, you can find it online at our website! (Dutch, willing to ship outside NL) ............ Update: ............ Although my version 2 was working great, I am working on a version 3, which has: - the top of the E3D-V6 better aligned to improve the bowden clip mounting - enable slightly better cooling of the E3D-V6 heatsink - an additional mounting area at the bottom for the original thermo couple amplifier PCB so your build plate is beautifully lightened by the blue led from the amplifier.