About this 3D model

This is a 3d printed version of the lasercut adapter plate for this laser found here: http://www.thingiverse.com/thing:18808 Mounting hardware needed: 2 M3 x 6(or 8) mm screws 2-4 M3 X 14+ mm screws 2-4 M3 nuts or pems Assembly instructions: Attach the laser to the mounting plate with the two M3x6mm screws. Do not over-torque them. Place the lase ron the laserbot on the top or bottom of the top mounting plate. If you place the plate on the bottom ot the top plate, be sure to put the back of the plate no farther back that the second row of holes. If you place the plate at the farthest back location, your scans will get obstructed by the rear standoffs. After the physical install, be sure to install the ROS hykuyo node.