About this 3D model

the classic Jurassic Park sign My settings for printing are the 0.2mm standard on Bambu slicer with a couple of tweaks: Fuzzyskin - Contour 0.4mm distance and 0.1mm thickness No Brim Wall Generator - Arachne increase the flow ratio slightly - go from 0.98 up to 1.05 Use a Textured PEI Plate and you should be all good The back plate is a tight fit - it can hold the light up on the wall without gluing For lighting on all of my light boxes I am using a USB powered LED light from Amazon with a bluetooth controller allowing me to control from my phone