About this 3D model

This design was intended to fill the need of whatever size spool you have or need to hold. I have included the F3D file (fusion 360 native file) so that you can take full advantage of the parameters I've used to model it: -Spool ID Hole Dia -Spool OD diameter -Distance above or below the mount to the wood (ZSpoolDist) -How far the spool sits away from the wood of the shelf (XSpoolDist) so the spool doesn't rub the shelf! -The width of the spool being used (Spoolwidth) to make sure the round part that holds the spool is long enough. I printed this in PETG, but since I do not have a stress tester, I have no idea the maximum limit of the holder. I have also modeled a little knob that will retain whatever spool you end up putting on the holder (so that it doesn't all come tumbling down)