About this 3D model

FFF printable MS01 front suspension and steering assembly replacement parts. Easy to print lower control arm support which keeps the lower control arms from dropping too low on an MS01 front suspension and steering assembly. Currently there are two options, a 1.5mm thick version and a 2mm thick version. Easy to print upper and lower strut tower pieces. Be sure to note orientation when building. MS01 assemblies can be ordered here: Kit: https://shop.makeitrc.com/collections/compatible-with-the-ffr-sc1-chassis/products/make-it-rc-ms01-ep-modular-front-suspension-and-steering-assembly-base-kit Fully assembled: https://shop.makeitrc.com/collections/compatible-with-the-ffr-sc1-chassis/products/make-it-rc-ms01-ep-modular-front-suspension-and-steering-assembly-assembled MS01 Instructions: https://shop.makeitrc.com/pages/ms01-assembly-instructions Print Settings Rafts: No Supports: No Infill: Solid Notes: A small size nozzle is highly recommended. Dimensional accuracy of the parts is important. Post-Printing For the strut tower pieces, its recommended to bore the holes to insure the rods and screws will fit. Drill the larger holes to 2mm and the smaller holes to 1.2mm.