About this 3D model

I needed a specific guide for the PTFE from side to back, as I don't have much room for the spool on the side on top and none of the holders was ok. So I remixed the PTFE guide for pegboard (was more simple than the original) and used a Side Rear mount for the Spool arm, put them together, and had exactly what I needed. Printed with Auto Tree supports, 0.2mm layer height, 3 perimeters, 15% gyroid infill - around 30 minutes on the P1P and uses around 15g of material. Used a P4-M10 for the PTFE and M3 screw with nut to hold it (didn't have anything else on hand) Please share your make. Big thanks to the original authors for the models.