About this 3D model

Print in place snapping slider fidget toy for the fidget toy design competition. Magnets are the fidgiest, so require some hardware: 2x Q-20-10-02-N magnets Recommended: Liquid glue IPA or something to wash the magnets with Instructions: To print first prepare the magnets, wipe them of with some IPA or soap and water to get the grease of the surface: Put a layer of glue on the two opposite poles so the plastic sticks on the magnet when printing: The print is going to pause 2 times, layer 19 and layer 42, place the magnets in the open slots, glue side up: The model is printed with a layer of BL Support W in the middle of the base and the snapper. Depending on how strong fingers you got it might be a bit tricky to separate. If you cant do it with finger force, try twisting the base and loose the slider a little bit, then shim a thin object between to lift the slider from the base: