About this 3D model

This is my version of a riser for the Bambu Lab P1S with ventilation and lighting. The riser is 30mm high and designed for LED strips with 10mm width. The lighting does not go all the way around, but only from the middle of the left side across the front to the middle of the right side. This is completely sufficient, as can be clearly seen in the pictures. In the front right corner, I have integrated a switch; in the back right corner, a DC jack. If no lighting is installed, or if the DC jack and switch are not needed, the same front right corner can be used as the left. For the back right, the part “Corner-back-right” is then used instead of “Corner-back-right-connector”. All parts are only plugged together; screws or glue are not necessary. The sliders for the ventilation openings are inserted before assembly. The ventilation extends over the same area as the lighting. All parts can be printed no supports. Only for the cutouts for the switch and DC jack have I used supports. I printed the ventilation parts ("Vent-parts-left(x2)", or “Vent-parts-right(x2)”) standing on their connecting sides. My material is PETG. PLA might have problems with the temperatures in the build chamber. Required hardware for the lighting: DC jack: https://www.amazon.de/St%C3%BCck-Steckverbinder-DC-Buchse-Buchse-DC-Einbaubuchse/dp/B09PD6J4BN/ref=sr_1_4?__mk_de_DE=%C3%85M%C3%85%C5%BD%C3%95%C3%91&crid=3LBF6V5W271O0&keywords=dc-buchse&qid=1699639679&sprefix=dc-buchse%2Caps%2C101&sr=8-4 Switch: https://www.amazon.de/Heschen-Schwarzer-rechteckiger-Wippschalter-Positionen/dp/B076VLJL37/ref=sr_1_3_pp?crid=1I5RZQLY3GR6V&keywords=wippschalter&qid=1699639865&sprefix=wipp%2Caps%2C130&sr=8-3 LED strip (10mm wide) and corresponding power supply unit The cutouts for the switch and DC jack may need to be adjusted if you use other models. This is easily possible using the Step files