About this 3D model

The design philosophy behind this P1S riser and cooling accessory is as simple and straightforward as its title It provides the most basic functions of a riser and top cooling and only raises the top by 4cm (removing the machine's lower recessed groove, the actual rise height is about 38mm) The design is extremely simplified, so its printing difficulty is not high, and it relatively saves filament Here I recommend PETG for printing I have not tested other filaments and cannot guarantee the print quality of other types of filament If you use the 3mf print profile I provided, the main body of the riser only requires 357g of filament The main body is assembled using a mortise and tenon pin structure, and can be assembled without any screws for fixation The exhaust component for the HMJ Riser System is now available for download Visit my homepage or click the link to find the model https://makerworld.com/zh/collections/15201781-hmj-riser-system Boost Me If you like it The main body can be printed in one go Feasibility verified on two machines Accessories to purchase: 1. 48 round magnets, 6mm diameter, 3mm thick [at least 48 needed, but it's best to buy a few extra] 2. 502 super glue [any glue that can bond magnets can be used, I personally use jewelry glue] 3. 3M EVA single-sided foam tape, 15mm wide, 1mm thick [This is optional; not installing this foam tape will not affect the use of the riser and cooling] Please install according to the instructions in the image The adhesion points for the 3M EVA tape are shown in the figure In addition to the positions shown in the image, tape can also be applied to the bottom of the riser The purpose of the tape is to provide a buffer layer for the glass top cover, preventing direct contact between the glass top cover and the riser and cooling bracket How to use the magnet auxiliary installation tool Q&A Why install a riser and cooling solution 1. Because without a riser and cooling solution, there's a high probability that the filament tube above the print head will rub against the top glass 2. It provides passive cooling space without opening the printer's chamber door or lifting the top glass, you only need to remove the magnetic cover, which is elegant and efficient ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ If you have spare magnets, you might consider printing a fidget toy I designed, navigate to the page by clicking the image below: Thumb switch link