About this 3D model

For this dry box I used the few printed parts and: -Ikea 792.767.60 dry box -4mm push-fit connectors (you can use cable glands) -PTFE tubes 4x1mm -20mm pipe -4x M3 screws, washers and nuts -some epoxy -silica gel You need two screw two axis holder across your box - you only need holes for the 3mm screws. My box fits two spools and I attached two connectors for each - one to get the filament out and additional one to stick the free end when not in use, sealing the box. The deviders are optional - to keep the spooles in place. The plug could be replaced by any cylinder with ca. 4mm diameter.