About this 3D model

This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid. I used a bit of hotglue to cover the hole for the LED. The light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) ) The pcb doesn't rattle inside the case and is kept tighly in its position. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: Yes Resolution: 0.1 Infill: 25% Filament: Colorfabb PLA black and red Notes: I used Cura for slicing. Printed with tree support, 0.1mm layer and 25% infill. Category: Electronics