About this 3D model

This is Large Model and will take the better part of a day on most printers Print Settings: Layer Height - 0.28mm Lightning Infill 20%+ (Very important, using regular infill increases filament usage and time to print significantly) 2 walls Other Notes about Printing Highly recommend using a glue stick to hold the print to the build plate Print the lid and base separately Magnetic Lid Uses (14) 6mm (width) x 2mm (depth) magnets Superglue the magnets into the holes May require some force to get the magnets into the holes, the holes are slightly bigger than 6mm Details: Tower is large (150mm x 150mm x 150mm) Lid covers the dice holes allowing for easier transport 60+ standard sized dice can fit in the slots. Dice can be no bigger than 22mm and cannot be smaller than 12.7mm. This should be fine for almost all dice and more than fine for standard (14mm - 16mm diameter) dice Dice tower rolls your dice and then deposits them into a dish at the bottom of the tower A DND Logo is engraved into the front wall of the tower (not pictured in the render) Dice tower should fit almost all dice and is designed to fit standard sized dice