About this 3D model

This enclosure fits the DS18b20 temp sensor I was able to order from Amazon. It was a few dollars more than AliExpress, but I had it in 2 days. It's smaller than most temp sensors, so I came up with a custom enclosure. It integrates perfectly with the XTouch Controller on my P1S. - Double-Stick tape used to secure sensor to the bottom of the enclosure. A drop of superglue to seal the case. - Link to the DS18B20 sensor used: https://a.co/d/fwWVSxL Project link: https://github.com/xperiments-in/xtouch