About this 3D model

Hello again all! This is a mount I designed for my purposes and to help all of you! I have an enclosed p1p (was done way before the p1s and kits were released) and for me my enclosure works great, reaching 160f just from the bed alone however once the bed is off the chamber cools and when I go to do another print I have to wait for the whole bed to get back up to temp as well as the chamber since I primarily print in ASA. This mount is designed to holster this chamber heater: https://www.amazon.com/dp/B0BRK7K2VW?psc=1&ref=ppx_yo2ov_dt_b_product_details This fits snugly into the mount with cutouts for the cable to run through and behind the mount to the back of the printer, It is designed to be able to put on either side of the printer (I have dual aux fans in my chamber). This heater has an auto on/off feature and I simply leave it set at 50c and it keeps my chamber nice and toasty, not too hot for PLA prints but just warm enough to be able to assist me in heating my bed up and keeping the chamber stable enough to start LARGE ASA prints without the initial warping from the print being in a colder chamber as it wouldnt have warmed up enough yet from the bed alone. I hope this helps all of you! Please dont forget to rate and leave a make if you do!