About this 3D model

These Decks are highly customizable in regards to the color options with the wood grain. I found it best to use a darker color as the base color and a lighter color for the grain pattern to prevent any bleeding. I highly recommend using the 3mf files as they are all precolored and the deck file contains the pause needed for the magnets. For the crates, I only printed single color so far. I have a two-color crate printing now but I have not yet printed a 4 Color Crate. (I Highly Recommend a Multi-Nozzle printer to print the 4 color crate) I know I also teased a photo with a grip tape deck but the grip tape I used was a really fine grit I had laying around the house and it works great but I dont know where it came from because its a bit old. I went to Amazon and ordered a few samples of adhesive grip tape to try out and they were all way too coarse and it would rip up your fingers so I am not going to do those right now. But honestly, this deck might be my new favorite, you guys let me know what you think. If you use the attached 3mf file in bambu studio the printer will pause at layer 25, at which point you put the magnets into the decks. I have found it easiest to hold the magnets in a stack and put the stack into a back hole and slide the stack forward and into the next hole. Place 8 magnets into one deck and FLIP the stack of magnets and repeat the process with 8 magnets in the second deck. Resume printing and the printer will print over top of the magnets and you will be ready to fidget as soon as the model is done printing. If you have not printed a KickFlip deck yet and you are wondering about magnet placement please check out this post https://www.patreon.com/posts/kickflip-magnet-121228896?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link There are 8 (8x3mm) Magnets embedded into each deck. The magnets can be purchased from Amazon using this link https://amzn.to/3V8lInO ALL models INCLUDING the crate are printed with NO Support material. These models were printed on stock Bambu Labs X1C or P1S printers. I use the 4 Color AMS system to print the models in color. Please let me know if you have any questions. Thank you! Mike