About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic nero Transmission Distance: 0.6 PLA Sunlu Purple Transmission Distance: 6 PLA BambuLab Basic grigio Transmission Distance: 0.5 PLA BambuLab Basic bianco Transmission Distance: 5 Swap Instructions: Start with nero At layer #5 (0.48mm) swap to Purple At layer #12 (1.04mm) swap to grigio At layer #14 (1.2mm) swap to bianco for the rest. Your last slider is set to 1.6mm which is lower than the model height.