About this 3D model

I wanted to cover the bolts on my Sim-Lab P1X simrig, which is on Simfeet. The simfeet are mounted with a M16 washer (diameter 30mm) and an M16 Nut. The design of the cap is 28mm internal height in my version, because my simrig is quite high on its feet. Height shall be adjusted to fit over the nut + additional length of the M16 thread sticking out. The logo's are 1mm thick, which allows printing 5 layers of white (in this case, based on 0.2mm profile), so that no infill pattern is visible anymore. Seam has been put on the back, so that it is not visible when positioned correctly. The prints were done on a Smooth PEI Plate (Carbon texture) on the 0.2mm Standard printing profile; Detect thin walls ON (especially on the Sim-Lab Logo, you will find that the white will cover better in the thin place) Seam position BACK (when the cap is placed, you will not have it in sight) First layer on 0.42mm (had the idea that this covered most of the area versus default 0.5) Bottom shell layers set to 5 (not necessary, but considering the amount of layers, it will not add much value or too much filament) Wall Loops 2 (found that this had the best result, but you can play with it). Sparse infill density 15%