About this 3D model

I never liked the handle on the AMS. It always felt like it was going to break the plastic. So I made this handle instead. It shifts the pivot point of the handle towards the back, so that it doesn't flex the plastic lid of the AMS as much. There are also four versions, each with the letter label of your AMS. I've found that the AMS handle comes with either 6mm screws, or 8mm screws. The included spacer rings are only needed if your AMS has 8mm screws and is meant to go on the underside of the lid (the rubber washers that came with the AMS go on the outside of the lid). You can find other models I have released for the X1C/AMS here: https://makerworld.com/en/u/2811301167/collections/109412