About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm You can complete this print without an AMS. Use the profile that says NO AMS and it will pause at the correct height instead of doing a filament change. At that point you change your filament and let it continue until the next pause where it will wait for the next manual filament swap. Filaments Used: PLA Eryone Black Transmission Distance: 5 PLA Eryone Grey Transmission Distance: 5 PLA Eryone White Transmission Distance: 5 Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Grey At layer #15 (1.28mm) swap to White for the rest.