About this 3D model

A reinforced version of the original part from 118 Design. The original is made of aluminum and can easily withstand the load of a strong spring. If it is made of PLA, it breaks after approx. 50-200 cycles, depending on which spring is used. This version has a higher wall proportion and chamfers and curves which minimize the predetermined breaking points. After printing, I heated and hardened the push rod on the 3mm axle rod with a lighter for about 5 minutes. (do not let it get too hot, always turn it a little and maintain a temperature of approx. 80-100 °C) Afterwards, the material warped and had to be reworked a little with a file. But now, in the end, it holds what it should without breaking.