About this 3D model

A fidget spinner for the desk of any chiefs fan! Also great for kids who are chiefs fans as well! You will want to put the outer arrowhead that spins around the inner arrowhead before screwing it into the base. If it's a tight fit, simply pinch slightly on the left and right sides of the arrowhead so it will bow up enough in the middle to allow the post to slide through the hole. You may need to cut or remove some filament from the screw portion of the inner arrowhead in order to get it to fit into the base. Depends on how fine tuned your printer is or what settings you use to print it on. At .2 it normally fits just fine but any lower quality than that and it doesn't fit as easily. Check out my other Chiefs designs here. Enjoy and go Chiefs!