About this 3D model

Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Used the head to create a helmet You will find more of such stuff in my collections: https://makerworld.com/en/u/2185604356/collections Description DUMMY 13 loves COMIC CON! So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON". The aim is to preserve the charm and simplicity of Dummy 13. Content of ScoutDUMM , sorry Scout Trooper: Helmet to use with an original black head Long-range scout weapon, as known from the original trilogy (Optional) Speeder Other parts are standard parts that are just printed in different colors (see pictures) You can find even more weapons in the Dummy 13 Weapons Pack V4.0 by mystoopidstuff . Printing: Layer height Brim Supports Helmet 0.15mm x x (Below the ears and on the upper edge of the eyes) Weapon 0.15mm for details - - Assembly: Helmet: Slide the head into the Helmet and press it in with gentle force on the chin. If this is not possible, it is probably due to the following points: Check the inside of the helmet (mostly the top and behind the eyes) to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife Add-on: Are you tired of walking through the jungle? Get your speeder here