About this 3D model

Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Used the head to design a helmet Used the armor for a new version You will find more of such stuff in my collections: https://makerworld.com/en/u/2185604356/collections Description DUMMY 13 loves COMIC CON! So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON". The aim is to preserve the charm and simplicity of Dummy 13. Content of DUMM3PO , sorry C3PO: Helmet to use with an original head (paint the area behind the eyes gold and and behind the mouth black) Armor with inlay Other parts are standard parts The arm connectors are simply glued-on ~1.5cm pieces of filament, just for fun. :D Printing: Layer height Brim Supports Helmet 0.10mm x - Armor 0.15mm ? - Inlay 0.10mm - - Assembly: Slide the head into the mask and press it in with gentle force on the chin. Check the inside to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife