About this 3D model

12mm Crosshair laser mount for the Comgrow Z1 Laser cutter engraver. Offset from centerline of laser for setting up in Lightburn is X27.07 and Y27.07 You will need to fine tune from there but that is a good starting point and printed right into the top of the mount. This mount replaces the clear Lexan cover on the top of the laser module and only requires 1 3X8mm screw to clamp the laser crosshair module. You will have to work out your own power source, I put a long USB cable on mine through the cable chain and run it from the same dock the laser is plugged into. I plug it in for setup then unplug it while burning.