About this 3D model

How did I print 5 colors with a bambu labs 4 color AMS? The tongue and antlers are both painted red in the slicer so start your print with the red filament and once the tongue is printed the 3mf file will pause the build. Take out the red filament and put in a brown roll. Resume the build and then when it goes to print the red antlers it will just pull the brown filament. For Rudolph, I put a dot of red acrylic paint on his nose with a tiny paint brush and let it dry. I also thought well there should probably be a doe version of this pickle so that will be coming within a few days. ALL of these designs are printed with NO supports & NO Brim. Please ensure you have proper bed adhesion for all of your models. I use a Textured Build Plate with Bambu Labs liquid glue. All of my models are printed on stock Bambu Labs X1C or P1S printers using the standard 0.04mm nozzle and a 0.16mmm (Maximum) layer height. I will use a 0.12mm layer height if I have the extra time for a nicer finish. I use the 4 Color AMS system to print the models in color. If you print the magnet files there is a pause added into the slicer at layer 24, when printing at a 0.16mm layer height. Once the printer pauses, simple place (1) 8x3mm magnet into each hole and then press resume on the printer. The printer will print directly over top of the magnets concealing the magnets inside and turning the pickles into little magnets. The magnets can be purchased from Amazon... https://a.co/d/1bVKYKB If you print the Keychain/Ornament version these little ball and chain keychains fits perfectly thru the hole... https://a.co/d/91ahEnS I used Stronghero3D Autumn pla - https://a.co/d/ja4kxMf for the pickle All other filaments not mentioned are standard solid pla filaments. Please let me know if you have any questions. Thank you! Mike