About this 3D model

This is a hilarious mugshot! Look at that guy :-) arrested! This is a hueforge print. You can print it without an AMS! Hotend: 0,40mm Print time: 2:52h Filaments Used: PLA Sunlu Meta Black PLA Sunlu Meta Grey PLA Sunlu Meta White Filament swap Instructions: Start with Black At layer #8 (0.72mm) swap to Grey At layer #12 (1.04mm) swap to White for the rest. Slicer instructions: layer height 0,08mm initial layer height 0,16mm sparse infill 100% sparse infill pattern “rectilinear” Before printing , make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints. Bad build plate adhesion is not related to the model. Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!