About this 3D model

A light box of your favourite cute psychopathic AI character, Miss Minutes. This light box is designed to use the LED Lamp Kit 001 available on the Bambu store, but you can alternatively fit an LED strip around the inside of the body it'll work just as well. It's designed so you can feed the cable for your lighting down either leg and shoe to help hide the cable on it's way out. It's all very simple and pushes together nice and easily. UPDATE 23.02.29 I'm happy to announce that I've uploaded a new version of the ‘Face’ part. The original tended to have a hotspot of light in the middle of the face due to the intensity of the light. This has been rectified by adding a slight increase in thickness behind the face, and making the ‘walls’ of the face part just 5mm deeper (adding less than 10 minutes to print time). This has completely sorted this problem, and I've also made adjustments to ensure that the eyes and mouth don't have yellow filter in from higher layers. A huge thank you to user @plc_one for their communication and suggestions in helping sort the hotspot issue! I've updated my profile (marked ‘Designer’) with the new face design, and have also replaced the STL with it too. Print Profiles Please note, my profile (Marked with the green ‘Designer’ box) will always feature the most recent reversions of the designs, but other profiles may feature older versions of the design. Printing Instructions Print the following: 1x - Face 1x - Back 1x - Left Arm 1x - Right Arm 2x - Leg 2x - Shoe Once printed, the arms just push into the slots on the side of the main body (the ‘Face’ part), then the legs slot into the body and the feet. It all pushes in and works great as it is, but if you wanted a little more rigidity, you can add the tinyest bit of glue to the legs and their fixings. The arms definitely wouldn't need it. Print Settings Layer height: 0.16mm (I printed it in 0.16 and that's what my profile is set to but really any size should work fine. This will really just impact the level of detail on the front of the hands and the top of the shoes). Material: PLA (Up to you, I used PLA for this but I'm planning on re-printing it using a glow in the dark yellow which I think could look pretty cool) Infill: Not too relevant for this print but I'm printing at 15% Gyroid infill If you have any questions, please feel free to get in touch.