About this 3D model

These little articulated wieners are made up of three pieces, the hot dog, the bun and the tray. Please notice there are two different versions. There is a regular version or a magnetic version that has one magnet embedded inside the hot dog and one inside the white tray to keep all three pieces together. The bun is pinched in between. The hot dog can then be moved thru the hole in the back of the tray, similar to the tickle pickles, and the entire set can also be used as a fridge magnet. Also Included are two versions of all three weenies. One with a hole for a keychain or a solid wiener. For all Bambu Studio users or anyone who can use a 3mf file, I recommend using the attached 3mf file. All of the models have been added to the build plate for convenience but I highly recommend printing all wieners at the same time, or all buns at the same time or all trays at the same time, to reduce waste. The pause has also been added to layer 32, where you would hand place the magnets inside the hot dogs. once your machine pauses. Simply place the magnets into the holes and resume build after the magnets are inside the holes. Please note: If you change layer heights you will have to adjust your pause. Adding/removing pauses can all be done after you slice your plate, using the vertical slider on the right edge of the screen. For anyone who cannot use a 3mf file all of the stl files are located in the zip file attached. Also, I messed up my first prototype because I am so used to assembly fidgets and reversing the magnet direction between the two side. The magnets will go in both pieces, the hot dog and the tray, in the same direction. Magnets are the same as most of my fidgets, 8x3mm and can be purchased from Amazon using the link below... https://amzn.to/3V8lInO All of my models are printed on stock Bambu Labs X1C or P1S printers using the standard 0.04mm nozzle and a 0.16mmm (Maximum) layer height. I will use a 0.12mm layer height if I have the extra time for a nicer finish. I use the 4 Color AMS system to print the models in color. FILAMENTS IN PHOTO ABOVE: Wiener Filaments: Ziro Matte Multicolor Rainbow Wood Grain pla (Please notice I think due to the matte finish you can see more of the seam along the top of the wiener. Ok, enough talk about wieners, I'm excited to make some videos!!! All other filaments not mentioned are standard solid pla filaments. Please let me know if you have any questions. Thank you! Mike