About this 3D model

This is my easel for hueforge paintings and other 2d- art! Assembly instructions: clip the leg to the stand, no glue needed. If the leg is not stable to the easel, just use a small drop of glue and glue it. Recommended filament: PLA Hotend: 0,40mm Print time: 0:39h assembly time: 1 minute Print instructions: layer height 0,20mm 2 wall loops top/bottom shells 4 layers top/bottom shell thickness 0,80mm sparse infill 10% sparse infill pattern “gyroid” enable support Support type “tree manual” Support style “tree slim” Support → enable “on build plate only” Support/object xy distance 0,5mm Before printing , make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints. Bad build plate adhesion is not related to the model. Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!