About this 3D model

This stl was created by Hueforge. To obtain good results you have to use the following settings: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Red At layer #11 (0.96mm) swap to Gray At layer #12 (1.04mm) swap to Jade White for the rest. If you have a filament from another brand you can still get good results in my experience, for example I tried with WINKLE filaments and it is still very nice.