About this 3D model

You can tell I was inspired by https://www.printables.com/model/418630-bambu-lab-integrated-hepa-carbon-aux-filter for sure, but this is a redesign from scratch. My 10x3 magnets were in reality only 2.6 mm thick so this cage is made to fit four of them stacked - in four places. I also added some ridges and adjusted sizes to make the cage sit very tight and secure. Find "GL2103 HEPA carbon filter" on eg. Amazon. Remove the plastic cage it comes in, and put the bare filter in this cage. Remove the three screws on your aux fan housing, put corresponding magnets on the inside of it with a drop of super glue (guided by the cage's magnets on the outside). I think I used 16 magnets on the inside as well, they barely fit between the fan and the housing. After that trivial installation, the cage is easily removed for filter replacement with no tools. Boost Me I mainly design stuff for myself and occasionally post them just in case someone else have use for them. You could want to spend your boosts on people with *really* cool ideas or designs (I try to give them to makers who don't have thousands of downloads already) - but having said that, I do appreciate a boost ?