About this 3D model

I wanted to use the fan of my mini heater to filter some bad fume inside my printer I used the bento box for the HEPA filter and then remix it with the mini heater rack and shield!!!! note you need the shield on the bottom with my bento heater Boost Me If you like my design, your support means a lot! Follow me, leave a rating, or give me a boost—every bit of encouragement helps. Thank you! I also used the aux fan cover that use same HEPA filter AUX fan cooling guide bottom shield Fan cover with Filter I also used the DS2 door seal with all these mods I keep the temp inside my printer at 51c when I print ASA or ABS all the parts are printed in ASA or ABS amazon link HEPA filter 10 pack 6 ft 90 degree angled power AC Mini heater m3 screws 6mmx2mm magnet I work on a way to control my inside temp with a thermostat but this will be in the future I also bought a wi-fi Power bar to power ON or OFF my heater and my added L.E.D. when I'm not near the printer