About this 3D model

Inspired by Fufu clips, but couldn't get them to fit, so I made this design. It has an inverter cup to keep your unwanted part concealed, but also allows for peeing. This is printed separately and slotted into the hole. Using the three holes, attach a sting in a jock-strap fashion, to hold in place. Then push in the unwanted part, and try to regress the balls inside you, and pull excess scrotum skin through the long slot which will keep everything tight, and give you a flush finish with the look of a labia through panties. I put the main section in hot water, and conformed it to the curve of my area for a good fit. I use for wearing sweatpants or jegging's when in public, so a bulge or standard cage isn't visible.