About this 3D model

a desiccant holder that fits with Bambu spools. Has a large enough flange to not fall through a sunlu spool. a similar that I downloaded the flange would go through some spools. And too tight on Bambu Spools. No support needed. I use a color changing bead desiccant. So it is easy to tell when you need to bake to dry them. I added a variable layer thickness to it to have a better surface for centering, and better threads a separate build plate has a funnel to help filling with desiccant. this funnel is perfect for “spiral vase”. In Bambu studio this is in “other” tab. I use these in the AMS and when stored. The extra weight added to the spool helps retract the filliment near the end of the roll. Before I started using these the retractions after a purge of almost empty spools would often fail. Another hint: Don't judge its fit of the cap by the first fit. If you assemble then work the joint, it wears the high spots. allowing subsequent assemblies to be much easier. Work the threads before you add the desiccant. added a version 2 it is a little smaller diameter and it has a graphic imbeded in the cap It is very thin so it will cause very little poop. The graphic shows what direction to turn. and also indicates the cap. Most of the spools I have will fit this diameter. The first version was 53mm dia. this is 48mm.