About this 3D model

Some of you may notice the look of this one. It is the same size and style as the OG King and Ace Card Fidgets. Many of you have requested a Queen and a Joker and I apologize it has taken this long. I did a Queen but never released it because I wasn't crazy with how it turned out but here is the Joker. Also I have gotten mixed reviews on these. Some of you like them as they are and other not so much. For my Patrons who still like this OG style I wanted to share the file but I also received some other feedback to improve these and I believe I can make a better set of cards so I'll be sharing those soon. For optimal fidgeting performance the bottom closure plate should be printed against a textured build plate. Each side has (6) 8x3mm neodymium magnets pressed into the holes, I use an arbor press for easy assembly. Remember to reverse the magnet polarity between the two sides. I highly recommend using the Attached m3f file, I slowed down the outer wall and top surface speeds a little bit, which results in a much nicer and much shinier surface finish. The magnets I used were purchased from Amazon, using the link below…. https://linktr.ee/mzmdigitaldesign Arbor presses can also be purchased on Amazon if you are planning on making more than a few of these. These were printed on a stockBambu Labs X1C and P1S Standard 0.4mm nozzle Fine Resolution 0.12mm layer height Infill: 20 As always please let me know if you have any questions! Thank you! Mike