About this 3D model

After months of annoying fiddling with my XT60 connector on my ZMR250, I finally got fed up and designed this handy mount. Unlike the other XT60 mounts, this XT60 mount has a very simple, and therefore, very universal design. It is designed to slide over the rear 5mm (OD) aluminium standoffs and hold your XT60 connector in a place where your wires won't get sucked into your props. Note that a little hot glue may be necessary on the bottom of the mount to ensure the XT60 doesn't slide out. Total weight: 12g (including antenna mount) Don't have a 3D printer? No problem! Purchase it on eBay! Updates 9/23/17: Added additional SMA/RPSMA antenna mount that slides over the standoffs after the XT60 mount. Note that this will add approximately 3g of extra weight to bring the total up to roughly 12g.