About this 3D model

A front cap for Hormann Remote Control Protective Sleeve (HSE4BS, HSE2-868-BS). To be used with Hormann HSE protective case by Jakub Kalfař . I uploaded a STEP file so you can change the dimensions if your doesn't fit. It's important it fits snug in the cover. Print Settings Material: PLA Layer height: 0.2 mm Perimeters: 3 Infill: 15% Supports: yes, used standard on manual settings and painted only the bottom part with overhang angle 30° (or 60° depending where you measure it from → see the picture bellow and adjust the settings so it looks like this). Other replacement parts If you broke yours like I did, here is a list of replacement parts I found and made to repair mine. Hormann HSE4BS replacement cover with a hole by Hologos Hormann HSE4BS remote control buttons by Hologos Hormann Remote Control Protective Sleeve/Cover Loop (HSE4BS, HSE2-868-BS) by Hologos Hormann Remote Control Protective Sleeve/Cover Back Spacer (HSE4BS, HSE2-868-BS) by Hologos Hormann Remote Control Protective Sleeve/Cover Front Cap (HSE4BS, HSE2-868-BS) by Hologos Hormann HSE protective case by Jakub Kalfař