About this 3D model

A beautiful hueforge print of a tiger in black and white. An AMS or MMU is not required, however will make the filament swapping a lot easier! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm Filaments Used: - PLA Siddament Black Transmission Distance: 0.2 - PLA+ Sunlu Grey Transmission Distance: 1.4 - PLA Overture Light Grey Transmission Distance: 1.6 - PLA META Sunlu White Transmission Distance: 9.6 Swap Instructions: - Start with Black - At layer #11 (1mm) swap to Grey - At layer #15 (1.32mm) swap to Light Grey - At layer #18 (1.56mm) swap to White for the rest.