About this 3D model

Inspired by the Voron 2.4 enclosure I made my own for the Prusa i3 MK3S+. Exterior Dimensions are 614 x 556 x 518mm . The Case is sealed from all sides but air can still flow in from below to vent the electronics. The whole enclosure sits on rubber feet (from High-End Audio Speaker). Additionally a Raspberry Pi 4 enclosure can be mounted inside and the HQ Camera attached to the aluminum extrusion. Printed Parts required: 16x Corner Piece 4x Hinges 2x Left Latch 2x Right Latch 2x Latch Base 6x LED Strip Angles 4x Rubber Feet Mounts Sourced Parts required: 8x Aluminium Extrusion 2020 - 500mm 4x Aluminium Extrusion 2020 - 560mm 44x Flat Head Screws M5x8 8x Nuts M5 8x Washer M5 36x T-Slot Nuts M5 6x Hex Screws M3x6 6x T-Slot Nuts M3 4x Round Magnets 7-8x1mm 2x Acryl Panel - 573 x 473 x 3mm 1x Acryl Panel - 573 x 513 x 3mm 1x Acryl Panel - 513 x 473 x 3mm 2x Acryl Panel - 472 x 255.5 x 3mm Compatible with following extensions: Filament Dry Box IKEA Samla 22L Raspberry Pi HQ Camera Arm & Case