About this 3D model

Boost Me This is third revision of this design. Maded reenfored of support beam and should be better than clips shown below. (clip is v1.2 design). The monitor will have 30 degree total adjustable angle, 15degree up, 15 degree down from center. This is functional part, be sure you read the description below: Monitor weight suggestions: below 15lbs. 24-27inch. Confirm you monitor clearance: Make decision if you like it or not, it will cost around 580g of filament and 14h to print, so. It's on you. Here are some clip, watch it first: And this one too: v1.1 design: v1.2 design: v1.3 design: Printing suggestions: PETG, PETG, PETGGGGGGGGGGGG, NO PLA. For these two: minimum with these setting: 45% infill at least. For the vertial beam: 55% infill at least, don't change to other non-ridgid infill pattern. BOM: Dimension: