About this 3D model

This accessory module is attached to the back of the Bambu printer via magnets, the module is equipped with a 12*12CM chassis fan, the air direction is towards the inside of the chassis. A filter cotton is installed on the outside of the fan to filter and purify the air, and the positive pressure keeps the enclosure clean and prevents dust and other dirt from contaminating the air. The lower part has a built-in drawer-type dustbin for easy cleaning. A 12mm PTC heating element can be added to provide cabin temperature control, and the cold air can be switched on by turning off the PTC. It has been tested and can be used for fully enclosed printing of PLA and PETG without any risk of clogging (in cold air mode). Magnet specifications 5*12mm, screw specifications 3.5*10mm head diameter 7 flat head self-tapping screws (British NO.6*3/8 flat head self-tapping screws).